• • 50 loads per hour

• • Unlimited

• • 56″ L
  • 56″ W
  • 80″ H

• • 146″ L
  • 130″ W
  • 122″ H

• • 2500 lbs

• • 120 V / 1 ph /60Hz 15A

• • 3 cfm @80 psi

• • Allen Bradley MicroLogix 1200 PLC
  • 24V control system
  • Current overload protection
  • NEMA 4/12 control cabinet (can be located up to 10′ from machine frame)
  • Autoheight sensing photoeye
  • Power on/off switch and status light
  • Start/stop push button
  • Large emergency stop (push / pull type)
  • Manual carriage up/down functionManual carriage up/down function
  • Variable rotary arm speed (12RPM)
  • Separate up and down carriage speeds
  • Separate top and bottom wrap selectors
  • Reinforced wrap/manual rotation control
  • Positive arm alignment controlled by proximity sensor
  • Top cover pause switch (Splash proof program)
  • Spiral up or spiral up/down switch
  • Film force to load control
  • Emergency stop sensor for arm path obstruction
  • Mode switch (Manual or Automatic)
  • Pull cord with 40′ of cable (to be installed by customer)
  • Separate station on front of tower with clamp jog and an additional e-stop
  • Lack of film alarm

• • 20″ NO-THREAD® Powered Pre-Stretch Carriage
  • 1 HP AC motor with Allen Bradley variable frequency drive
  • Lifetime warranty on pre-stretch rollers blue compound
  • Film force release for easy pull at start and end of cycle
  • 50-400% pre-stretch ratio (preset to customer spec, Std 200%)
  • Electronic film tension control with analog sensor
  • Lexan roller cover for operator safety
  • Angled carriage to wrap approximately 2″ from floor level
  • Proximity sensor on carriage gate to ensure gate is properly close

• • 1 HP AC motor with Allen Bradley variable frequency drive
  • Two #50 carriage lifting chains
  • Dual 1/2″ CRS ways with UHMW-PE carriage glides
  • Dual structural steel supporting boom
  • Power track for efficient guiding of wires

• • Automated Cut/Clamp & Wipe system
  • Pulse controlled cutter
  • Film alignment arm & brush on film tail treatment

• • Heavy duty 25″ ring gear with pinion gear drive
  • 1 HP AC motor with Allen Bradley variable frequency drive
  • 0-12 RPM variable speed
  • Electronic soft start/stop
  • Positive arm alignment controlled by proximity sensor
  • Protection guard over the ring gear

Structure

• • Wulftec recommends using heavy-duty expansion shields of 3/4″ diameter thread size with a minimum anchor depth of 4″ in concrete.

• • The machine is provided with a manual including electro/mechanical schematics and drawings, troubleshooting guide & installation instructions

• • 4-year unlimited cycle warranty
  • lifetime warranty on prestretch rollers
  • 10-years on the steel structure and ring gear